12-22-2013, 10:17 PM
(12-22-2013, 08:35 PM)LordCrass Wrote: I ran into this problem today installing the software on my laptop which is Win7 64-bit.
...
Maybe if the driver file is manually copied to the correct directory it will work without the board?
Yes, your assessment is correct. I had noted a workaround in this thread, but Jim edited the forum to remove it shortly after I posted it. I'll give it again, and hope that it sticks around this time.
You can temporarily copy the FTD2xx.dll to the SCP install directory, where the SCP software can find it, until the drivers are installed completely after connecting the hardware the first time.
Good luck!
Robert