(11-27-2021, 10:40 AM)admin Wrote: For any cartridges that use the $E000 address you need to make sure that the reset type is set to not use Exrom. This was not the default for the first few dozen boards that I shipped out. You can check and change this through the OLED screen and menu. The real dead test cartridge uses $E000.
The v1.2 manual doesn't appear to have a lot of info regarding the wiring and connecting of the OLED.
Is there a separate doc for that?
Thanks again!
UPDATE:
I took a quick look at the add-ons & accessories for the ICS64 and realized that there's enough info there for me to work with...
(e.g., It's an I2C display, as opposed to an SPI, it uses a custom pin-out of VCC/GND/SCL/SCA, etc.)