08-15-2022, 06:58 AM
Thanks again for helping me out.
I actually was able to get the software to see the board again. I tried Jeff_Birt's suggestion, although there actually was no driver to remove listed for some reason. I'm not sure if that's bad, but I was able to use it before—all my archiving software is on its own VM so I think it hasn't been touched since last time. Either way I was able to get the board to be seen.
I'm still unable to get floppy drives to be seen, unfortunately. I can't even get them to show signs of life. When I apply power to my 5.25" drive it starts spinning but that's it, and it doesn't work or get detected when connected to the SCP. The Huey/Duey chips don't look like they're damaged to me, but maybe I'm not seeing it?
![[Image: hJ15Blt.jpg]](https://i.imgur.com/hJ15Blt.jpg)
![[Image: 2uZemIR.jpg]](https://i.imgur.com/2uZemIR.jpg)
Maybe they did get damaged and it's just not visible though. I definitely installed the cable wrongly earlier, my 3.5" drive doesn't have a foolproof connector.
I actually was able to get the software to see the board again. I tried Jeff_Birt's suggestion, although there actually was no driver to remove listed for some reason. I'm not sure if that's bad, but I was able to use it before—all my archiving software is on its own VM so I think it hasn't been touched since last time. Either way I was able to get the board to be seen.
I'm still unable to get floppy drives to be seen, unfortunately. I can't even get them to show signs of life. When I apply power to my 5.25" drive it starts spinning but that's it, and it doesn't work or get detected when connected to the SCP. The Huey/Duey chips don't look like they're damaged to me, but maybe I'm not seeing it?
Maybe they did get damaged and it's just not visible though. I definitely installed the cable wrongly earlier, my 3.5" drive doesn't have a foolproof connector.