12-23-2020, 09:30 AM
(12-22-2020, 04:41 PM)admin Wrote: It prints fine. I printed 4 cases a few days ago with my CR-10. It made me realize that I do need to change the case so that it is held together with screws instead of CA (super-glue).
Hi, on checking my printer one of the levelling screws had come loose as well as some of the mounting bolts so I need to sort that out
and re-level my printer then I'll try and print it again. Thanks for the reply, knowing the file was okay it got me to check out the printer
which I hadn't done in a little while.