CBMSTUFF FORUM › CBMSTUFF PRODUCTS › SX-64 Ultra Reset › Installation
Troubleshooting

Linear Mode
Troubleshooting
admin Offline
Administrator
*******
Posts: 2,796
Threads: 146
Joined: Nov 2013
#2
04-08-2017, 09:30 PM
The blue wire is the reset line. If it has to be removed then there is a problem likely with the build or the blue wire is not on the correct location, or there is a short. Can you post a picture of the assembled board (top and bottom) and wires?
Website Find
Reply


Messages In This Thread
Troubleshooting - by css123456 - 04-08-2017, 08:51 PM
RE: Troubleshooting - by admin - 04-08-2017, 09:30 PM
RE: Troubleshooting - by css123456 - 04-09-2017, 12:05 PM
RE: Troubleshooting - by admin - 04-09-2017, 12:47 PM
RE: Troubleshooting - by css123456 - 04-10-2017, 06:26 PM
RE: Troubleshooting - by css123456 - 04-12-2017, 06:33 PM
RE: Troubleshooting - by admin - 04-12-2017, 07:14 PM
RE: Troubleshooting - by css123456 - 04-12-2017, 07:20 PM
RE: Troubleshooting - by admin - 04-13-2017, 04:27 PM
RE: Troubleshooting - by css123456 - 04-13-2017, 05:18 PM
RE: Troubleshooting - by admin - 04-13-2017, 07:13 PM



Users browsing this thread: 2 Guest(s)