"no answer" and "no update" function
#1
Nice Christmas greetings from Germany.  Angel
I have bought  the Wifi modem and have now connected it.

I found my router with it and could connect it.
A link to atdt google.com:80 also brings a CONNECT.
Currently the software version 1.6 is on it ..

An automatic update does not work, see picture.
In an attempt to address a BBS, unfortunately, no ANSWER.

Can it be that i also can only enter small letters?
ATDT GOOGLE.COM:80 does not work, atdt  google.com:80 CONNECT   is o.k.

Can I somehow manuel an update of the firmware make or can I even downgrade?

Thank you for your support
Greetings Mike

               
Reply
#2
Rainbow 
I found the error and could now use the WIFI modem in the Internet.
So I was able to make an update to v1.7.

The error or the difficulty is the Wifi modem does not want to work with my WPA2 security connection.
The modem can not access ports other than: 80 via the open GUEST connection.

It works on my main WLAN, but I have to switch off my WPA2 encryption.

Is that normal ?

Which secure WLAN can the WIFI modem work with?

Thank you, Greetings Mike
       
Reply
#3
(12-25-2016, 07:05 AM)C64Mike Wrote: Which secure WLAN can the WIFI modem work with?

Thank you, Greetings Mike

it works  Heart Cool

the problem was, that my WPA2 phrase has not only No. but also little letters,...
when i use only numbers in my WPA2-Code  , the CBM-Wifi-modem can connect to the WPA-Router,..

thank you very mutch Big Grin Tongue
Reply
#4
I use letters and numbers in my passphrase without any issues. Are you using AES or TKIP encryption in the WPA2 protocol? AES has been successfully cracked, so most router companies are dropping it. I am not sure what the ESP8266 library has for support.
Reply
#5
(12-26-2016, 10:09 AM)admin Wrote: I use letters and numbers in my passphrase without any issues.  Are you using AES or TKIP encryption in the WPA2 protocol?  AES has been successfully cracked, so most router companies are dropping it.   I am not sure what the ESP8266 library has for support.

Hello

I have tested it now again.

I had previously stored in the router lowercase letters with numbers as code.
With this setting, I could not go online on the C64, no matter whether I wrote large or small letter.

If I use in the router as a passphrase ONLY big letters, then I can log on the C64 with the wifimodem and use there only small letters.

What type of WPA2 I use? yes, I use AES unfortunately ...
Now it works

Greetings Mike
Reply
#6
You MUST be in ASCII terminal mode when entering your router name and passphrase.
Reply
#7
Yes,
This was probably the general problem,
And yes, it is also correct in your instructions, ..  Sorry   Angel

But now everything works and also an update of the software on V1.7

Now I'm just waiting for the ATA command :-))  Big Grin

Thank you and happy new year
Mikel
Reply
#8
ATA command has been available since v1.6!
Reply




Users browsing this thread: 2 Guest(s)