Firstly, I've really enjoyed populating the board over the last few months. Been interesting (mainly on the parts ordering side), but I'm pretty close to populating with ICs...
During the voltage tests I've found the User Port voltage measurement is at the max recommended level on Page 89 at 5.25v. Other voltages are within range, it's just this one. Is this okay, or should I be looking somewhere specific for a fault/component issue?
Thanks,
Phil.
During the voltage tests I've found the User Port voltage measurement is at the max recommended level on Page 89 at 5.25v. Other voltages are within range, it's just this one. Is this okay, or should I be looking somewhere specific for a fault/component issue?
Thanks,
Phil.