12-12-2014, 11:25 AM
If you remove J1, it kills power to the board. Replacing J1 restores power to the board, so that will reset it. You should not have to unplug the USB cable to kill the power.
|
How to Guide - Flashing firmware
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to Guide - Flashing firmware - by admin - 11-06-2013, 02:36 PM
RE: How to Guide - Flashing firmware - by Mousey - 12-12-2014, 02:12 AM
RE: How to Guide - Flashing firmware - by admin - 12-12-2014, 11:25 AM
RE: How to Guide - Flashing firmware - by Mousey - 12-15-2014, 03:17 AM
RE: How to Guide - Flashing firmware - by admin - 12-15-2014, 07:34 AM
RE: How to Guide - Flashing firmware - by Mousey - 12-16-2014, 01:38 AM
RE: How to Guide - Flashing firmware - by admin - 12-16-2014, 11:09 AM
|
Users browsing this thread: 1 Guest(s)