11-03-2014, 09:53 AM
The SuperCard Pro board is missing pin 5 - it does not have a full set of pins.
I connect/disconnect the drive power and ribbon all of the time with the power on, but if you accidentally cross match pins, you will damage the board. So, if this is a concern to you then you should make sure that there is no power going to the board and/or drive while connecting cables.
Any 3.5" molex connector will work. I sell the floppy power adapters.
I connect/disconnect the drive power and ribbon all of the time with the power on, but if you accidentally cross match pins, you will damage the board. So, if this is a concern to you then you should make sure that there is no power going to the board and/or drive while connecting cables.
Any 3.5" molex connector will work. I sell the floppy power adapters.