11-25-2025, 05:31 PM
Today I was using my WiModem232 and after a at&w the LED went out.
I modified a few things prior to the at&w.
at*busy=in a call write now call back later
ats0=9
at&w
that caused the LED to go out.
I've tried to set the LED via at*led5, at*led0, at*led1, nothing is bring it back.
I did reboot and complete power cycle nothing helped it.
I use that LED to see who is trying to login to my system.
I don't see anyone else with this issue.
firmware: v6.50-01/20/25
I modified a few things prior to the at&w.
at*busy=in a call write now call back later
ats0=9
at&w
that caused the LED to go out.
I've tried to set the LED via at*led5, at*led0, at*led1, nothing is bring it back.
I did reboot and complete power cycle nothing helped it.
I use that LED to see who is trying to login to my system.
I don't see anyone else with this issue.
firmware: v6.50-01/20/25