Windows 11

[admin]

OK, thanks.

[morduk2]

Hi Jim,

I tried the card you sent back to me.  Again the same problem, when copying a disk for a ADF image. The copy grid indicate the bottom part of the disk cannot be read (red color) yet the top part of the disk is green, indicating that information was read.  The equipment being used is "newer" except for the floppy drive.  The drive goes thru all 80 sections of the disk, but the image is flawed.  Is the floppy drive out of alignment or is there something else I should check?  

Since you repair Supercards and check them before you sent them back,  do you use a modern floppy drive or the antiques that most of us use to check for errors?  If you use a modern drive could you share the make and model.

Thanks before hand

[admin]

I use a standard 3.5" floppy drive like everyone uses. I typically use a Sony MPF-920 or Panasonic JU-257, both of which are very common.

Red means absolutely NO data is being found (bad head).