03-04-2024, 02:37 PM
(This post was last modified: 03-04-2024, 03:00 PM by shawn.henson73@gmail.com.)
Im using the wimodem232 with amiga 3000.
Everything works fine except when I want to up or download files.
I get
Data packet too large Then
bad data packet crc-32
The term program is set at 19200 8n1
Serial port on the amiga is set for 19200 8n1 RTS/CTS and buffer at 1024
Im using zmodem for transfers (but it does it with any protocol )
Modem is on current firmware 6.20 6/3/23
modem also reports 19200 8n1
What stupid simple thing am I missing?
Ive done this and no change
Problem: I connected to a BBS and when I start a download it immediately
starts having bad blocks and retries.
Solution: Make sure that the translation mode is set to 0 (AT*T0). This
turns off the Telnet translation.
Everything works fine except when I want to up or download files.
I get
Data packet too large Then
bad data packet crc-32
The term program is set at 19200 8n1
Serial port on the amiga is set for 19200 8n1 RTS/CTS and buffer at 1024
Im using zmodem for transfers (but it does it with any protocol )
Modem is on current firmware 6.20 6/3/23
modem also reports 19200 8n1
What stupid simple thing am I missing?
Ive done this and no change
Problem: I connected to a BBS and when I start a download it immediately
starts having bad blocks and retries.
Solution: Make sure that the translation mode is set to 0 (AT*T0). This
turns off the Telnet translation.