02-20-2018, 08:00 PM
I've recently got one of these lovely devices and I'm having problems with hardware handshaking.
If I try to enabled it for a 19200 8n1 I just get error when using at&k1. I seem to get error no matter what AT&K setting I use. However it did work once and things were great I could connect to a lot more BBS's but when I wrote the settings AT&W it's never worked again.
I've tried it on an Atari STE 1048 (direct in the port) as well as a Mega STE (through a 9/24 pin cable) always the same result. Otherwise it works very well and that's awesome.
Thanks!
_Troy
If I try to enabled it for a 19200 8n1 I just get error when using at&k1. I seem to get error no matter what AT&K setting I use. However it did work once and things were great I could connect to a lot more BBS's but when I wrote the settings AT&W it's never worked again.
I've tried it on an Atari STE 1048 (direct in the port) as well as a Mega STE (through a 9/24 pin cable) always the same result. Otherwise it works very well and that's awesome.
Thanks!
_Troy