03-24-2023, 07:59 PM
(03-24-2023, 06:56 PM)admin Wrote: AT&F is the ONLY thing that will reset the OFFHOOK string unless you have somewhere that does AT*OFFHOOK= (without any text, which will erase the text completely).
Check to see what firmware version you are really using (ATI). I tested this a bunch today and everything works perfectly.
What is in the "RESET.MDM" file?
You SHOULD be using AT&K1 with anything over 2400 baud. AT&K0, AT&K2, and AT&K3 all turn OFF the hardware flow control. You WANT that on for your BBS. Without the hardware flow control, you will have errors sending any large chunks of data when the receiver is telling the sender to stop sending data.
Okay, then I know I'm not using AT&F anywhere, *unless* it's something that's hardcoded into BBS Express! ST and if so, well...I have no control over that.
ATI shows v6.01 on all my WiModem232's as of today.
The "RESET.MDM" file contains 2 commands at the moment, "ATH" and "AT&K3".
"AT&K1" - okay, well that's good to know. I had googled for what each of those settings meant
and never got that K3 turned it off. /sigh. I will change those commands in all my *.MDM files
to "AT&K1".
Thanks Jim.