03-24-2023, 01:38 PM
I just tried this again and it works fine here. Storing the OFFHOOK string using AT&W and then sending ATZ shows the OFFHOOK string just fine. You might try that to verify that you aren't changing the OFFHOOK message somewhere in your BBS initialization. Also, check to make sure you are using the v6.01 firmware (use ATI).
There already is a message that is sent to the caller when the BBS does not respond after 10 ring attempts (10 seconds). That message is hard coded to say "AUTO-ANSWER TURNED OFF!" I did this for cases where the BBS has crashed.
There already is a message that is sent to the caller when the BBS does not respond after 10 ring attempts (10 seconds). That message is hard coded to say "AUTO-ANSWER TURNED OFF!" I did this for cases where the BBS has crashed.