Using higher speeds...?

[DarkLord]

Well...I was a little unsure how to proceed with this, so I did the following.

From TAZ (comms software) I used AT*B38400 on the WiModem232 but
did NOT save it

I then enabled the RSVE mod.

The red LED on the mod comes on, which is supposed to mean faster than
19.2 speeds. In this case, I'm using the HSModem software to remap 19.2
speeds to 38.4 baud.

I then reopened TAZ which now fails to communicate with the WiModem232.

Nothing in the documentation even mentions "RTS/CTS/DTR/DSR/DCD"...

Thanks.