Possible to downgrade firmware?

[Mr.Micro]

Have you tried calling the WiModem while you are using CCGMS to see what is going on?  You should see RING, RING, RING over and over until you type ATA<RETURN> to do the answer.

I am not sure what to think.  If you go back to the previous version it should be back to the previous firmware. I did not try using something other than 6400 for the port, I will change my setup to use 6401 and see if that makes some type of difference.

The AT&F definiately resets everything except the baud rate in EEPROM to preset values.  So, your port would be reset back to 6400, not 6401.  So, if you are expecting to be using port 6401 it is definitely not going to work!

>>The AT&F definiately resets everything except the baud rate in EEPROM to preset values.  So, your port would be reset back to 6400, not 6401.  So, if you are expecting to be using port 6401 it is definitely not going to work!

I understand that and know better. I'm already forwarded on 6400 with a different modem to keep my BBS active, the same one the Wimodem ran on port 6400. I only switched the Wimodem to 6401 on a different 64 so you could test it in a terminal.

>>If you go back to the previous version it should be back to the previous firmware.

It does rollback the firmware, just not the problem that came after the update. Or at least ATI shows it's rolled back.

>>Have you tried calling the WiModem while you are using CCGMS to see what is going on?

Yes, several times and It goes, 10 (Connect 2400) and then to 3 (NO CARRIER) instantly. Never get a chance to ATA. This is why I set the terminal up for you to see. I just came in and see someone (or something) was trying to connect, there's a bunch of 10's & 3' on the screen. Calling from CCGMS with 2 different modems (non Wimodems), works flawlessly and one of them is now running the BBS until I/we can get this straightened out.