10-03-2020, 12:35 PM
The USB/FIFO test runs but neither reports success or failure. It just displays send/receive and an incrementing byte value but nothing else. I'm guessing if there was a problem it would be displayed?
I have used this same computer to image a few hundred disks and there has never been an issue.
Is the uC on the SCP just clobbering the FDTI FIFO/USB interface and overwriting the buffer? I'm surprised that there is no data integrity check on the PC side of things (CRC etc.)
I did use the laptop to image the two disks for the TPPD1/2 and I made duplicates of each so I'm certain the SCP works fine.
I have used this same computer to image a few hundred disks and there has never been an issue.
Is the uC on the SCP just clobbering the FDTI FIFO/USB interface and overwriting the buffer? I'm surprised that there is no data integrity check on the PC side of things (CRC etc.)
I did use the laptop to image the two disks for the TPPD1/2 and I made duplicates of each so I'm certain the SCP works fine.