05-20-2020, 09:45 PM
The WiModem232 should be returning that error - because you are not entering the syntax correctly. To view the value of any command, you need to end it with a question mark (?)
So, to see the value for AT*BUSY, type:
AT*BUSY?
To set a new value type:
AT*BUSY=[new value]
I see that setting the new value is actually not correct in the manual (missing the = character). I will change that.
So, to see the value for AT*BUSY, type:
AT*BUSY?
To set a new value type:
AT*BUSY=[new value]
I see that setting the new value is actually not correct in the manual (missing the = character). I will change that.