Hi Jim,
The left side top support bracket (the one that goes around the VGA port) hits the pin headers, so I had to trim that part down a bit on my bracket. On the right side, the button bar mount I trimmed the top edge of it a bit down so it wasn't so tight against the pin headers on that side. Wanted to allow for a bit of manufacturing variation.
So, in the end, very little had to change. Just the two top support pieces. Otherwise still a good fit.
BTW, great board!
Thomas
P.S. If you want to print the two revised support brackets for your case, I'd be happy to send you those STLs. Just lemme know.
The left side top support bracket (the one that goes around the VGA port) hits the pin headers, so I had to trim that part down a bit on my bracket. On the right side, the button bar mount I trimmed the top edge of it a bit down so it wasn't so tight against the pin headers on that side. Wanted to allow for a bit of manufacturing variation.
So, in the end, very little had to change. Just the two top support pieces. Otherwise still a good fit.
BTW, great board!
Thomas
P.S. If you want to print the two revised support brackets for your case, I'd be happy to send you those STLs. Just lemme know.