12-08-2019, 06:12 PM
(12-08-2019, 05:21 PM)admin Wrote: Typically it's obvious when the SuperCard Pro board is damaged because Huey and/or Duey will usually have a burn mark on surface of the chip. Can you take a close up picture of those chips and post it?
If the board is fine, then it could be that you don't have the correct jumper settings for the drive.
I'm pretty sure I never inserted the cable incorrectly.
I used the same cable with a 3.5 drive originally - just to make sure things were working prior to starting experimenting with 5.25 drives.
Anyhow - here's the hi-res picture of the chips in question:
hi-res picture
The picture exceeded the size limits for a post - and I didn't want to reduce the resolution to fit...
Jim