12-08-2019, 05:21 PM
I have never seen a Tandon drive before, so I don't have any experience with this one. Either the drive motor on this drive is not working, the cable is bad, or the SuperCard Pro board was damaged. If you ever plugged the cable in backwards, the board would be immediately damaged. The damage can be anything from no index to no motor.
Typically it's obvious when the SuperCard Pro board is damaged because Huey and/or Duey will usually have a burn mark on surface of the chip. Can you take a close up picture of those chips and post it?
If the board is fine, then it could be that you don't have the correct jumper settings for the drive.
Typically it's obvious when the SuperCard Pro board is damaged because Huey and/or Duey will usually have a burn mark on surface of the chip. Can you take a close up picture of those chips and post it?
If the board is fine, then it could be that you don't have the correct jumper settings for the drive.