01-23-2019, 09:28 AM
OK, so let me get this right. You need 0x5F to also function as the standard CR (0x0D), but only in COMMAND mode? I don't need an alternate CR for doing this, and I would never make any new S-Register that was not a valid Hayes standard. Instead, I could make a WiModem specific ('*' command) that enabled/disabled the feature. Something like AT*TS1 to enable it and AT*TS0 to disable it. What I don't know is if you need 0x0D output to the terminal (from the WiModem) or 0x5F, or both?
I am adding the Autodial feature. A new WiModem specific command (AT*Ax) will be created. Where 'x' is 0 for disabled (default), or 1 for enabled. So, when you power up the modem and the router is found, it will attempt to connect to the first phone book entry when this feature is enabled. Once the connection is lost it requires a power-cycle for this to happen again automatically.
I am adding the Autodial feature. A new WiModem specific command (AT*Ax) will be created. Where 'x' is 0 for disabled (default), or 1 for enabled. So, when you power up the modem and the router is found, it will attempt to connect to the first phone book entry when this feature is enabled. Once the connection is lost it requires a power-cycle for this to happen again automatically.