11-24-2017, 10:18 PM
I have recently purchased the Supercard Pro and followed all instructions to the Letter.
At first I had to fix error 713 on Windows 8.1, but was able to fix it.
Next on my first 3.5" floppy it would not recognize Track 0, which I can't seem to find any reference on this site. I have also noticed on my SCP software I don't have any selection for a 3.5" drive, only 5.25". Since I didn't have a 3.5" drive selection I tried changing from 5.25" 96TPI to 48TPI. I managed to get one ADF copy of one floppy before everything failed completely.
Now I can no longer get my source to show SuperCard Pro, and it no longer allows me to make an image, only Start Conversion.
I also tried to save configuration, but it does't seem to be working. I tried to Load configuration and it started where both Source and and Target were Supercard Pro. A few times I changed to ADF image files. Because I couldn't save my Configuration I tried to Reset to Default, and from this point onward I could no longer select Source: SuperCard Pro and no longer create image.
What is going on, has the firmware corrupted? Please advise asap..regards
PS: included Image of Screenshot of SCP
At first I had to fix error 713 on Windows 8.1, but was able to fix it.
Next on my first 3.5" floppy it would not recognize Track 0, which I can't seem to find any reference on this site. I have also noticed on my SCP software I don't have any selection for a 3.5" drive, only 5.25". Since I didn't have a 3.5" drive selection I tried changing from 5.25" 96TPI to 48TPI. I managed to get one ADF copy of one floppy before everything failed completely.
Now I can no longer get my source to show SuperCard Pro, and it no longer allows me to make an image, only Start Conversion.
I also tried to save configuration, but it does't seem to be working. I tried to Load configuration and it started where both Source and and Target were Supercard Pro. A few times I changed to ADF image files. Because I couldn't save my Configuration I tried to Reset to Default, and from this point onward I could no longer select Source: SuperCard Pro and no longer create image.
What is going on, has the firmware corrupted? Please advise asap..regards
PS: included Image of Screenshot of SCP