11-12-2013, 06:08 PM
Beta 0.41 adds the ability to change the Density select line in the analyzer. Drives like the FD-55GFR can be told to read at 300RPMs or 360RPMs. Using a slower drive speed gives you much more accurate reading and writing.
Changed the menu from Settings to Drive Settings, adding the Density selection and added control for the Flip-It mod. WARNING! This uses PIN33, so if you enable this with a No-Flip (flippy) modded drive, it will mess up the Track 0 sensing... so, don't use it unless you have the Flip-It mod installed.
Lots of little clean up and changes throughout as well.
Changed the menu from Settings to Drive Settings, adding the Density selection and added control for the Flip-It mod. WARNING! This uses PIN33, so if you enable this with a No-Flip (flippy) modded drive, it will mess up the Track 0 sensing... so, don't use it unless you have the Flip-It mod installed.
Lots of little clean up and changes throughout as well.