CBMSTUFF FORUM › CBMSTUFF PRODUCTS › SuperCard Pro › Developer Area
Device initialisation

Linear Mode
Device initialisation
admin Offline
Administrator
*******
Posts: 2,853
Threads: 148
Joined: Nov 2013
#10
02-26-2016, 08:16 PM
I would expect this. This is no different than if you were to pull a FDC card out of an XT card slot. The drive lines will float. You MUST have the SuperCard Pro powered up either before or at the same time as the floppy drive. There are no exceptions to this rule.
Website Find
Reply


Messages In This Thread
Device initialisation - by obo - 02-06-2016, 12:02 PM
RE: Device initialisation - by admin - 02-06-2016, 02:54 PM
RE: Device initialisation - by obo - 02-06-2016, 08:08 PM
RE: Device initialisation - by dfstudios - 02-06-2016, 08:32 PM
RE: Device initialisation - by admin - 02-06-2016, 09:09 PM
RE: Device initialisation - by obo - 02-07-2016, 04:59 AM
RE: Device initialisation - by admin - 02-07-2016, 09:46 AM
RE: Device initialisation - by obo - 02-07-2016, 04:03 PM
RE: Device initialisation - by obo - 02-26-2016, 05:45 PM
RE: Device initialisation - by admin - 02-26-2016, 08:16 PM



Users browsing this thread: 1 Guest(s)