02-07-2016, 04:03 PM
I usually have the drive connected to a separate power brick, which always has power. The SCP only gets power when it's plugged in and my PC is on, so it's always going to start up after the drive. I think I had the same drive setup with the KryoFlux board, though I've used that a lot less overall so I might not have noticed whether it did the same.
I'll either change to my ALPS drive (which is probably better anyway), or use the power from the SCP board. I'll still add a software work-around in case anyone else is affected by the same issue (just one person so far).
I'll either change to my ALPS drive (which is probably better anyway), or use the power from the SCP board. I'll still add a software work-around in case anyone else is affected by the same issue (just one person so far).