12-30-2015, 05:22 PM
Hi, thanks for your reply.
On your recommendation, I tried splice mode with the following settings:
Drive type - (5.25" - 96tpi)
Weakbits - (Fixed)
Density (Read - Low), (Write - Low)
Index Sensor - (Read - required), (Write - Required)
Backside Control - (None)
Source - (SuperCard Pro (Drive 0)
Target - Flux image
Checked options (Preservation)
Start Track 1
End Track 38
Disk Types (C64/128)
Copy Mode - (Splice)
I'm now able to successfully copy anything I've thrown at it (including my Superkit disk ... YEAH!)... BUT... and yes there's a BUT... I can only copy the front side of any of my disks.
All of my attempts to copy the back side have failed completely.
When I put the disk in to make a flux copy, it complains about the index sensor. If I go into the settings to make it "not required" for reading, it creates the flux image. However, when I write it to a blank disk, I cannot read the disk on my Commodore.
Wondering what I'm doing wrong now...
Any thoughts?
Thanks for your time.
Thomas
On your recommendation, I tried splice mode with the following settings:
Drive type - (5.25" - 96tpi)
Weakbits - (Fixed)
Density (Read - Low), (Write - Low)
Index Sensor - (Read - required), (Write - Required)
Backside Control - (None)
Source - (SuperCard Pro (Drive 0)
Target - Flux image
Checked options (Preservation)
Start Track 1
End Track 38
Disk Types (C64/128)
Copy Mode - (Splice)
I'm now able to successfully copy anything I've thrown at it (including my Superkit disk ... YEAH!)... BUT... and yes there's a BUT... I can only copy the front side of any of my disks.
All of my attempts to copy the back side have failed completely.
When I put the disk in to make a flux copy, it complains about the index sensor. If I go into the settings to make it "not required" for reading, it creates the flux image. However, when I write it to a blank disk, I cannot read the disk on my Commodore.
Wondering what I'm doing wrong now...
Any thoughts?
Thanks for your time.
Thomas