05-17-2015, 05:16 PM
For standard commercial disks, just use INDEX mode tracks 1-38 with the C64 disk type. That's really it.
MAKE SURE you have a disk head cleaner and use it frequently!! It only takes one crummy disk to dirty the head where nothing will read from that point. I am typically cleaning the head just about every disk that I image.
You are always welcome to send .scp images... you can send them to data (@) cbmstuff.com
You can also load an image into the editor/analyzer and take a look at the flux graphically. It's REALLY easy to see if the disk is bad or head is dirty.
I am working on the .d64 creator. My goal was to try to get that done today, but it's not going to happen. I have to re-write the GCR converter to be just like the 1541 and syncronize the SYNC bits.
MAKE SURE you have a disk head cleaner and use it frequently!! It only takes one crummy disk to dirty the head where nothing will read from that point. I am typically cleaning the head just about every disk that I image.
You are always welcome to send .scp images... you can send them to data (@) cbmstuff.com
You can also load an image into the editor/analyzer and take a look at the flux graphically. It's REALLY easy to see if the disk is bad or head is dirty.
I am working on the .d64 creator. My goal was to try to get that done today, but it's not going to happen. I have to re-write the GCR converter to be just like the 1541 and syncronize the SYNC bits.