(01-29-2015, 07:43 PM)telengard Wrote:(01-29-2015, 05:45 PM)admin Wrote: What cable are you using? Did you look at the jumper settings information in the Hardware section?
I'm using one similar to the one in the manual, but with just the connectors for the PCB finger connections (not the 3.5 style) and it has a twist at the far end.
I will look in that forum, didn't realize it was there, thanks!
~telengard
Putting the jumper back on DS2 from DS1 matches up my jumper settings with diagram perfectly, except for TM which is not jumpered. Some spots do not have jumpers but are hard wired (but they match up with a jumper being required in that spot).
I also tried another cable, same results...
~telengard