02-04-2014, 03:20 PM
Quote:Information about the .scp image file is not shown at all.Infact, so i have to open the .ipf first, see how many tracks it contains, convert it to .scp and then I must set the start/end track correctly. If .scp file already contains start/end track they could be set automatically (always leaving the user the possibility to change them after if necessary before starting real write to file)
Quote:This is normal, and deliberate. This saves wear and tear on the drive motor by leaving it on for a period of time. A drive that has been spinning for awhile has a more accurate speed. So, when copying multiple disks the drive will usually stay on the entire time until you are done.so this means I can extract the original disk with the light of the drive still switched on? Could it be I ruin the disk by doing this?
Quote:Any option for a 5.25" drive only applies to a 5.25" drive. Ignore this setting unless you are using a 5.25" drive.ok, fine I tought (my bad) applicationw as detecting the drive type, instead it was just an option that could be set