03-24-2023, 06:32 PM
Jim, what "AT" command would reset or wipe the "AT*OFFHOOK" command?
I'm just trying to figure out if there's anything in my BOOTUP.MDM, F10.MDM or RESET.MDM
files that would cause this. Here is what each has in it:
BOOTUP.MDM (whenever BBS Express! ST is first started)
ATH
AT&K3
F10.MDM (exits the program, returns to the desktop)
ATH1
AT*OFFHOOK=The DarkForce! BBS Is Currently Offline - Please Try Again Later...
RESET.MDM (runs whenever Express goes from "online" to "offline")
ATH
AT&K3
In case you're wondering, if I don't have the AT&K3 command in there, the WiModem232 always
goes back to AT&K0. I don't know why. Saving with AT&W makes no difference.
I'm just trying to figure out if there's anything in my BOOTUP.MDM, F10.MDM or RESET.MDM
files that would cause this. Here is what each has in it:
BOOTUP.MDM (whenever BBS Express! ST is first started)
ATH
AT&K3
F10.MDM (exits the program, returns to the desktop)
ATH1
AT*OFFHOOK=The DarkForce! BBS Is Currently Offline - Please Try Again Later...
RESET.MDM (runs whenever Express goes from "online" to "offline")
ATH
AT&K3
In case you're wondering, if I don't have the AT&K3 command in there, the WiModem232 always
goes back to AT&K0. I don't know why. Saving with AT&W makes no difference.