11-14-2022, 06:04 PM
You need to know if a BBS is using a Telnet or RAW connection before you call it. If it is using a Telnet connection, you have to set the WiModem232 to use Telnet mode (AT*T1). Telnet is a protocol that some portals use.
I am in contact with the SYSOP at ONYX about this and I am working on it. I can see the same problem you describe on my PC using internet direct (no WiModem232) using ZOC8, or SyncroNet.. but NetRunner works correctly. So, this must be either a Telnet issue or something related to ANSI codes. Only the Telnet would make a difference, as data is data and the WiModem232 only passes data. Only Telnet mode is different.
I have not looked at ANY of the other WiFi modems. I have been making the WiModem series since 2015, before anyone else was doing this.
I am in contact with the SYSOP at ONYX about this and I am working on it. I can see the same problem you describe on my PC using internet direct (no WiModem232) using ZOC8, or SyncroNet.. but NetRunner works correctly. So, this must be either a Telnet issue or something related to ANSI codes. Only the Telnet would make a difference, as data is data and the WiModem232 only passes data. Only Telnet mode is different.
I have not looked at ANY of the other WiFi modems. I have been making the WiModem series since 2015, before anyone else was doing this.