02-26-2020, 10:05 AM
(This post was last modified: 02-26-2020, 10:06 AM by natevw.
Edit Reason: clarify first sentence
)
Sorry, to be clear I do *not* own any alignment disk, so I am starting from scratch (nothing I can duplicate myself unless someone can share flux files from theirs).
If I fill in a track using the Analyzer/Editor tool with all FF bytes and write as FM [which based on the commands run during the test procedure I think is what's expected, i.e. the controller is told to read a track while in single density mode] the resulting flux that it writes will end up similar to a 125kHz signal? Why does the guide call it a "2F" pattern?
If I fill in a track using the Analyzer/Editor tool with all FF bytes and write as FM [which based on the commands run during the test procedure I think is what's expected, i.e. the controller is told to read a track while in single density mode] the resulting flux that it writes will end up similar to a 125kHz signal? Why does the guide call it a "2F" pattern?