08-06-2019, 11:18 AM
Make sure that you use the resistor that is on the board so that the current is kept at or below 5mA for each LED.
|
My Compaqt solution
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
My Compaqt solution - by Vipersan - 08-04-2019, 11:16 AM
RE: My Compaqt solution - by admin - 08-04-2019, 09:21 PM
RE: My Compaqt solution - by Vipersan - 08-05-2019, 02:11 AM
RE: My Compaqt solution - by admin - 08-05-2019, 07:23 PM
RE: My Compaqt solution - by Vipersan - 08-06-2019, 01:43 AM
RE: My Compaqt solution - by Vipersan - 08-06-2019, 03:17 AM
RE: My Compaqt solution - by admin - 08-06-2019, 09:47 AM
RE: My Compaqt solution - by Vipersan - 08-06-2019, 10:04 AM
RE: My Compaqt solution - by admin - 08-06-2019, 11:18 AM
RE: My Compaqt solution - by Vipersan - 08-06-2019, 12:28 PM
RE: My Compaqt solution - by Vipersan - 08-06-2019, 02:39 PM
RE: My Compaqt solution - by admin - 08-06-2019, 11:34 PM
RE: My Compaqt solution - by Vipersan - 08-07-2019, 12:38 AM
RE: My Compaqt solution - by admin - 08-07-2019, 08:57 AM
RE: My Compaqt solution - by Vipersan - 08-07-2019, 09:02 AM
RE: My Compaqt solution - by Vipersan - 08-07-2019, 09:45 AM
RE: My Compaqt solution - by admin - 08-07-2019, 04:34 PM
RE: My Compaqt solution - by Vipersan - 08-08-2019, 12:29 AM
RE: My Compaqt solution - by Vipersan - 08-08-2019, 07:52 AM
RE: My Compaqt solution - by admin - 08-08-2019, 08:00 AM
RE: My Compaqt solution - by Vipersan - 08-08-2019, 08:01 AM
RE: My Compaqt solution - by Vipersan - 08-09-2019, 02:50 PM
RE: My Compaqt solution - by admin - 08-09-2019, 04:17 PM
RE: My Compaqt solution - by Vipersan - 08-10-2019, 03:29 AM
RE: My Compaqt solution - by natevw - 02-05-2020, 10:42 PM
RE: My Compaqt solution - by Vipersan - 02-26-2020, 05:38 AM
|
Users browsing this thread: 1 Guest(s)