CBMSTUFF FORUM › CBMSTUFF PRODUCTS › WiModem232 / WiModem232 Pro v
Some hang-up issues

Linear Mode
Some hang-up issues
admin Offline
Administrator
*******
Posts: 2,787
Threads: 146
Joined: Nov 2013
#5
02-02-2018, 08:45 PM
The DTR hang up feature is already supported.  You will need to cut the jumper between IN and RTS and bridge the connection between IN and DTR.  Optionally, you could just jumper RTS to DTR on your cable.  You will lose RTS/CTS flow control because the WiModem232 can only support RTS/CTS or DTR/DSR, not both at the same time.  I don't have DSR supported in the hang up mode because I can't find any information about DSR being used in this way.  Use AT&D2&K0 to enable the hang up mode.
Website Find
Reply


Messages In This Thread
Some hang-up issues - by Baldrick - 01-31-2018, 12:59 PM
RE: Some hang-up issues - by Baldrick - 01-31-2018, 05:07 PM
RE: Some hang-up issues - by admin - 01-31-2018, 05:11 PM
RE: Some hang-up issues - by Baldrick - 02-02-2018, 05:58 PM
RE: Some hang-up issues - by admin - 02-02-2018, 08:45 PM
RE: Some hang-up issues - by Baldrick - 02-03-2018, 06:28 AM
RE: Some hang-up issues - by admin - 02-03-2018, 09:19 AM
RE: Some hang-up issues - by Baldrick - 02-12-2018, 04:54 PM
RE: Some hang-up issues - by admin - 02-12-2018, 11:22 PM
RE: Some hang-up issues - by Baldrick - 02-17-2018, 04:18 PM
RE: Some hang-up issues - by admin - 02-17-2018, 04:40 PM
RE: Some hang-up issues - by Baldrick - 02-17-2018, 06:22 PM
RE: Some hang-up issues - by admin - 02-17-2018, 07:18 PM
RE: Some hang-up issues - by Baldrick - 02-18-2018, 05:28 AM
RE: Some hang-up issues - by admin - 02-18-2018, 10:08 AM
RE: Some hang-up issues - by Kailef - 02-19-2018, 10:36 PM
RE: Some hang-up issues - by geneb - 07-18-2019, 09:49 AM
RE: Some hang-up issues - by admin - 07-18-2019, 03:11 PM
RE: Some hang-up issues - by geneb - 07-18-2019, 04:27 PM
RE: Some hang-up issues - by admin - 07-18-2019, 08:15 PM



Users browsing this thread: 1 Guest(s)