01-28-2018, 03:08 PM
Yes, as noted in the manual the default baud rate is now 300 baud, not 2400 baud. When the update occurred it reset everything to factory defaults - including the new default baud rate.
zterm/ccgms not working anymore after update to 2.x ?
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
zterm/ccgms not working anymore after update to 2.x ? - by Amon_RA - 01-28-2018, 08:52 AM
RE: zterm/ccgms not working anymore after update to 2.x ? - by Amon_RA - 01-28-2018, 12:00 PM
RE: zterm/ccgms not working anymore after update to 2.x ? - by admin - 01-28-2018, 03:08 PM
|