01-19-2016, 09:05 AM
Jumper J1 must be in place unless you are powering the board using the Molex drive connector.
Are any floppy drives connected when this happens? When you plug the SCP into the USB port, does the BLUE LED light up? It could be that your USB port voltage is too low (not 4.85v or higher per spec).
The system thinks that your board is in firmware upgrade mode, which means the BLUE LED would be on as well. When you power up the board you should see the RED LED come on solid for 1 second, flash several times, and then turn off and the GREEEN LED turn on.
Are any floppy drives connected when this happens? When you plug the SCP into the USB port, does the BLUE LED light up? It could be that your USB port voltage is too low (not 4.85v or higher per spec).
The system thinks that your board is in firmware upgrade mode, which means the BLUE LED would be on as well. When you power up the board you should see the RED LED come on solid for 1 second, flash several times, and then turn off and the GREEEN LED turn on.