12-30-2015, 09:00 PM
Reduce the number of revolutions, that has nothing to do with the jumper. If you want to read the backside of a disk by just flipping it over you must have the EX jumper set. MS is not required, but should not be a problem from what I can tell.
The error message you see is due to the track length x 5 (5 revolutions) being larger than what the onboard memory can hold. Just reduce the revolutions to 4... You really only need one or two, depending on the type of disk.
The error message you see is due to the track length x 5 (5 revolutions) being larger than what the onboard memory can hold. Just reduce the revolutions to 4... You really only need one or two, depending on the type of disk.