03-16-2015, 08:06 PM
No luck so far, but I'm just getting started.
I'm using a FDADAP from DBit.com to convert from 34-pin to 50-pin.
When SCP starts, the LED display does briefly display "0". However, SCP doesn't show any drives. I've tried two of my 8 inch drives so far. I have others to try as well.
Any tips? Is there a way to display more debugging info about what SCP sees on the bus?
I'm using a FDADAP from DBit.com to convert from 34-pin to 50-pin.
When SCP starts, the LED display does briefly display "0". However, SCP doesn't show any drives. I've tried two of my 8 inch drives so far. I have others to try as well.
Any tips? Is there a way to display more debugging info about what SCP sees on the bus?