04-07-2014, 07:22 AM
There is really no way to test the SCP's floppy port. If you plugged the cable into the board with the red stripe on the wrong (opposite) side of the connector, it can destroy the board's floppy drive interface port.
The manual has pictures of the cable connection, red stripe orientation, etc. That must be followed.
Are you powering the SCP with a USB port connected to a hub with at least 500mA of current?
The manual has pictures of the cable connection, red stripe orientation, etc. That must be followed.
Are you powering the SCP with a USB port connected to a hub with at least 500mA of current?