CBMSTUFF FORUM › CBMSTUFF PRODUCTS › Supercard+ › Installation and setup
1541 installation

Linear Mode
1541 installation
admin Offline
Administrator
*******
Posts: 2,933
Threads: 148
Joined: Nov 2013
#5
06-12-2025, 10:15 AM
Yes, you just remove the 6502, put it on the Supercard+ board, and then plug the Supercard+ board into where the 6502 was removed.

The software adjustment is available here in the forums:

https://www.cbmstuff.com/forum/showthread.php?tid=39

You can run the TEST program on disk 1, side 1 to test the board.
Website Find
Reply


Messages In This Thread
1541 installation - by admin - 09-15-2019, 11:04 PM
RE: 1541 installation - by transnet - 07-04-2020, 03:57 PM
RE: 1541 installation - by admin - 07-04-2020, 04:33 PM
RE: 1541 installation - by NiallEd - 06-12-2025, 04:45 AM
RE: 1541 installation - by admin - 06-12-2025, 10:15 AM
RE: 1541 installation - by NiallEd - 06-12-2025, 05:54 PM
RE: 1541 installation - by admin - 06-13-2025, 02:22 PM
RE: 1541 installation - by NiallEd - 06-13-2025, 05:59 PM
RE: 1541 installation - by admin - 06-14-2025, 11:40 AM
RE: 1541 installation - by NiallEd - 06-14-2025, 06:14 PM
RE: 1541 installation - by NiallEd - 07-04-2025, 05:38 AM
RE: 1541 installation - by admin - 07-07-2025, 11:02 AM
RE: 1541 installation - by NiallEd - 07-07-2025, 06:45 PM
RE: 1541 installation - by admin - 07-08-2025, 12:26 PM
RE: 1541 installation - by NiallEd - 07-08-2025, 06:42 PM
RE: 1541 installation - by admin - 07-09-2025, 12:16 AM
RE: 1541 installation - by NiallEd - 07-09-2025, 07:13 PM
RE: 1541 installation - by admin - 07-09-2025, 08:34 PM



Users browsing this thread: 1 Guest(s)