05-29-2025, 10:56 AM
The LED is not I2C. If you did not trim the 4 solder joints that are on TOP of the display, you can break the circuit board (barrels for the signal pass-through) when using a 3D printed case. You have to trim those to be below the height of the glass! People who make these cases don't tell you that. I have had quite a few people end up with broken boards and displays due to the various cases made.
That is the correct display! MAKE SURE you trim the 4 solder joints on that display before you install it!
That is the correct display! MAKE SURE you trim the 4 solder joints on that display before you install it!