AT&F has no effect on the baud rate. I did at&f after the upgrade and downgrade.
it seemed like at&f didn't do anything until another setting was changed first; i changed k0 to k1. Then at&f took.
after doing at&f, at&k1, at*bl512.
same results still throwing exception. But this time much faster. First ls produced an exception.
it seemed like at&f didn't do anything until another setting was changed first; i changed k0 to k1. Then at&f took.
after doing at&f, at&k1, at*bl512.
same results still throwing exception. But this time much faster. First ls produced an exception.