10-20-2024, 06:15 PM
Hi everyone,
I recently pulled my WiModem232 out of storage, it is the OLED display model that says v3.1 in the corner, to start using again after a recent move. I was able to connect it all up, connect to the Wi-FI, but when I try to run AT*UPDATE I get
"Process failed! - Wrong HTTP Code"
before it just resets back to connecting the router. I know it's been a bit since I've used it, but not sure what to do to get this to install?
Thanks all!
Josh
I recently pulled my WiModem232 out of storage, it is the OLED display model that says v3.1 in the corner, to start using again after a recent move. I was able to connect it all up, connect to the Wi-FI, but when I try to run AT*UPDATE I get
"Process failed! - Wrong HTTP Code"
before it just resets back to connecting the router. I know it's been a bit since I've used it, but not sure what to do to get this to install?
Thanks all!
Josh