+- CBMSTUFF FORUM (https://www.cbmstuff.com/forum)
+-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1)
+--- Forum: SuperCard Pro (https://www.cbmstuff.com/forum/forumdisplay.php?fid=3)
+---- Forum: Software (https://www.cbmstuff.com/forum/forumdisplay.php?fid=6)
+---- Thread: Update loop (/showthread.php?tid=886)
Pages:
1
2
RE: Update loop - Kris - 05-08-2022
I already updated the firmware to v1.3 but it still difficult to have the card recognized.
I checked my antivirus etc... but nothing is supposed to block the access.
No more idea yet.
RE: Update loop - admin - 05-08-2022
Nothing has ever changed with the USB. Did you start having this issue after updating the firmware?
RE: Update loop - Kris - 05-08-2022
Nothing changed with the USB, and I got the issue even before updating the firmware.
I tried several times today and I got it detected once after 5 or 6 times, then I unplugged the SCP and try again, same thing.
RE: Update loop - admin - 05-10-2022
Sounds like maybe you have a USB port or cable issue. Have you tried a different port or cable?
RE: Update loop - Kris - 05-10-2022
I did try a new USB cable and different port but same results.
RE: Update loop - admin - 05-11-2022
What type of disk drive are you using, and how are you powering it?
RE: Update loop - Kris - 05-11-2022
I'm using a 3" CPC floppy disk but the issue is coming from my laptop: I tried with another one and everything is OK.
RE: Update loop - admin - 05-11-2022
It could be that your laptop does not have enough current on the USB port if you are powering the CPC drive from the SuperCard Pro board. I am not sure how much current a CPC drive uses.
RE: Update loop - Kris - 05-11-2022
The CPC drive is powered externally so no matter from here.
I think "smartscreen" or an other soft may be the cause of my issue, I will check that.
EDIT: I just install W11 and my concern disappear, everything is back on track, thank you for your support.