CBMSTUFF FORUM
Connected modem to ATARI XL - Printable Version

+- CBMSTUFF FORUM (https://www.cbmstuff.com/forum)
+-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1)
+--- Forum: WiModem232 (https://www.cbmstuff.com/forum/forumdisplay.php?fid=79)
+--- Thread: Connected modem to ATARI XL (/showthread.php?tid=758)



Connected modem to ATARI XL - Sleepy - 09-23-2020

Hi,

I connected my new WiModem232 sucessfully to my Atari 8-bit using an ATARI 850 interface.

There was a little trap. The four serial ports of the ATARI 850 interface look like normal RS232 ports (D Sub, 9pole, female), but the pinout is not the pinout known from pc. Also, the four ports are not identical. Port 1..3 can be used for RS232, port 4 is a current-loop for TELETYPE-machines. Port 2 and 3 doesn´t support all RS232-Signals. I used port 1 for the WiModem.

Owed to the 850s unusual pinout, you can´t use a standard 9pole-to-25pole-dongle to connect WiModem. I build a selfmade wired like this:

   

Sleepy


RE: Connected modem to ATARI XL - admin - 09-24-2020

Thanks for the info!


RE: Connected modem to ATARI XL - Tillek - 05-30-2021

It should be noted that the ICD P:R: Connection and ICD MIO use the same pinouts for their RS232.

The MetalGuy66 reproduction of the MIO uses standard RS232 cables.

I don't remember for certain if the ICD P:R: Connection's Port 2 is identical to port 1, or a "stripped down" port like the 850's, but I'm almost certain it's normal.

A few of us have been using these quite successfully for both running and calling BBS's both on the Atari 8-bits and the ST's. It's a great device.


RE: Connected modem to ATARI XL - admin - 05-31-2021

Thanks for the new info! Glad you like the WiModem232!