SCP Program does not exit - Printable Version +- CBMSTUFF FORUM (https://www.cbmstuff.com/forum) +-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1) +--- Forum: SuperCard Pro (https://www.cbmstuff.com/forum/forumdisplay.php?fid=3) +---- Forum: Installation and setup (https://www.cbmstuff.com/forum/forumdisplay.php?fid=5) +---- Thread: SCP Program does not exit (/showthread.php?tid=214) |
SCP Program does not exit - SomeGuy - 02-28-2015 Got the SCP software installed, it seems to work OK, and successfully backed up a known copy protected disk. But when I try to exit the program, it just sits there unresponsively. It won't even close when I tell Windows to end the task. Any ideas what the issue is? Other than that, so far it looks like a good tool with a good set of features. I look forward to playing around with it some more. (I hate the blue LED though ) RE: SCP Program does not exit - admin - 03-01-2015 That would be a Windows USB problem. What version of Windows are you using? Are you using any type of anti-virus program that monitors the USB ports? RE: SCP Program does not exit - SomeGuy - 03-01-2015 The machine I am using it on has Windows XP. There isn't much else on it. The only things on it that seem like they could be relevant are VirtualBox, VMWare, A TOPPS Eprom programmer (gotta love that Engrish), an Epiphan USB VGA Video capture tool, and an HP 1300 USB laserjet. Interestingly, the software works fine inside a Virtualbox VM if I forward the appropriate device. RE: SCP Program does not exit - admin - 03-01-2015 If it works under VM then there is definitely a Windows USB issue of some kind. RE: SCP Program does not exit - SomeGuy - 03-02-2015 Well, I tried a few more things to narrow it down. I threw a completely fresh Windows XP install at it, and it still hung at exit. Even before I installed any chipset drivers. Nothing seemed to have any affect, but then I tried throwing in a PCI USB card an attaching the board to that - and that worked. So it seems like the SCP does not like the ports on this motherboard or perhaps its USB drivers. The motherboard in question is a BIOSTAR A770E3. RE: SCP Program does not exit - admin - 03-02-2015 Hmm... SCP uses the FTDI driver for it's USB handling. I will look to see if there is some sort of known compatibility problem with that motherboard. RE: SCP Program does not exit - admin - 03-04-2015 I didn't find any mention anywhere of compatibility issues with any motherboards. The only compatibility issues were fixed last year, and those had to do with certain USB hubs not working correctly. |