bad data packet crc-32 - Printable Version +- CBMSTUFF FORUM (https://www.cbmstuff.com/forum) +-- Forum: CBMSTUFF PRODUCTS (https://www.cbmstuff.com/forum/forumdisplay.php?fid=1) +--- Forum: WiModem232 / WiModem232 Pro (https://www.cbmstuff.com/forum/forumdisplay.php?fid=79) +--- Thread: bad data packet crc-32 (/showthread.php?tid=1070) |
bad data packet crc-32 - shawn.henson73@gmail.com - 03-04-2024 Im using the wimodem232 with amiga 3000. Everything works fine except when I want to up or download files. I get Data packet too large Then bad data packet crc-32 The term program is set at 19200 8n1 Serial port on the amiga is set for 19200 8n1 RTS/CTS and buffer at 1024 Im using zmodem for transfers (but it does it with any protocol ) Modem is on current firmware 6.20 6/3/23 modem also reports 19200 8n1 What stupid simple thing am I missing? Ive done this and no change Problem: I connected to a BBS and when I start a download it immediately starts having bad blocks and retries. Solution: Make sure that the translation mode is set to 0 (AT*T0). This turns off the Telnet translation. RE: bad data packet crc-32 - shawn.henson73@gmail.com - 03-04-2024 Found a answer in another thread https://www.cbmstuff.com/forum/showthread.php?tid=419&pid=2882#pid2882 RE: bad data packet crc-32 - admin - 03-04-2024 Yes, you definitely need to set the translation mode to match what you are connecting to! Also don't forget that you need to enable the hardware handshaking using AT&K1. |