10-09-2018, 11:08 AM
The earlier versions used the exact same microseconds for every single track. That resulted in a problem for me when hand testing each SuperCard Pro board because if the writing didn't work, the test would pass because of a previous write. I changed the microseconds used for the test so it changes randomly for each track/side to prevent this problem from happening. The window for failures was also narrowed a bit.
Take a look at a track that fails using the editor/analyzer. Read the track that fails and look at the flux display. It should be pretty obvious why it failed. I have no issues here with the 1.2MB drives that I use - they all pass the media tests just fine with standard DSDD disks. Most people use 1.2MB drives, and I have not had anyone else report this.
Take a look at a track that fails using the editor/analyzer. Read the track that fails and look at the flux display. It should be pretty obvious why it failed. I have no issues here with the 1.2MB drives that I use - they all pass the media tests just fine with standard DSDD disks. Most people use 1.2MB drives, and I have not had anyone else report this.